Gary Palmer wrote:
Russ,
May I suggest a slight modification to your concept that would be even simpler.
Split the two high pressure pumps to the two separate FI rails; one to the pair of
primary injectors, and the other to the pair of secondary injectors. In the event of
failure of one of the pumps, you simply switch Tracy's controller into injector failure
mode for the appropriate injector pair. If I recall correctly (IIRC) this increases the
duty cycle of the remaining operational injectors to maintain enough fuel flow for at
least 80% power.
This approach eliminates the cross-over valve. Coupled with a couple of pressure
switches, one per rail, and some relay logic, or even a built in enhancement to the
EC2, the pump failure and mode switchover could be automated.
Hmm. Very interesting indeed. I think I still would prefer to have the injectors
balanced on the rails (#1 primary and #2 secondary on one rail, #2 primary and #1
secondary on the other rail). So perhaps Tracy's engine controller could be modified to
understand that the fuel rails are separated in this way? Then we have the best
arrangement: equal fuel consumption (between tanks), 80% power limp home mode (if fuel
injector pump or pressure regulator fails), no cross connect valve needed. I like it!
While I had planned a simpler system exploiting the normal Lancair header tank in my
235, this approach has the appeal of getting fuel out of the cockpit, and moving my CG
back to compensate for the higher weight of the 13B compared to a Lyc O-235.
Yes, the header tank is gone, and the fuel injection pumps are in the tanks (and not the
engine compartment), both actions move the CG backwards. You need to allow for the high
pressure fuel lines from the tanks to the engine compartment.
Russell Kent
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org