Subject: Reasons for apex seal failure
From: Paul
Date: 2/12/2000, 6:29 AM

Barry Gardner wrote:

Paul,

I wanted to throw out a question to more experienced rotary-heads
than me.

We know that the Mazda rotary can have a very long life. In fact,
I received this note this week from a guy driving a
normally-aspirated 13B from the 89-91 series car, who has 340,000
miles on the original engine (albeit at the lower power levels
found in automotive driving):

Marcus wrote: "Longevity?  Just follow the factory recommended
service intervals.  Really.
Oil changes (engine, tranny, and rear end), plugs and filters,
coolant,
brakes fluid, hoses.  If you're an airplane guy, then you know
what I'm
talking about.  It's about being proactive, rather than reactive.
I don't
use any special fluids, just a regular schedule.  In my case,
it's 5,000
miles on the oil changes, between 20K and 30K for plugs, every
year for
coolant. Every couple of years for tranny and diff oil.  Just a
normal
schedule for me."

On the other hand, I have two engines from normally-aspirated
RX7's (one in the garage, the other still in a car) that have
blown apex seals. The one still in the car has a blown seal on
the rear rotor (I haven't tested the engine in my garage).

Normally, when I think of what generates a blown apex seal, I
think "detonation." I also own an 87 Turbo and I'm going to be
watching that problem closely as I make any modifications,
knowing that denotation is a risk for too much boost. However,
what would give rise to blown apex seals on the
normally-aspirated motor? Are there any other causes that more
experienced people can suggest?

Over on one of the car lists, they suggest that a lean fuel
condition can cause a blown apex seal. However, on this list
(based, perhaps exclusively, on Tracy's experience), the settled
wisdom is that a lean condition can be safely tolerated because
there are no valves to burn. Can a lean condition cause apex seal
problems?

Perhaps it can cause detonation which can fracture an apex seal.
I intend to install detonation sensor off of the late engines
in my turbo version. PL


Readers should also know that, while my 88 normally-aspirated
engine has one blown seal, the engine did not fail
catastrophically, still starts and runs, but will not idle below
2000 rpm and, of course, does not generate full power. That
sounds like enough power to get my plane somewhere safe to land
except perhaps over high elevation terrain where near-full power
output would be required to stay aloft. I feel good about that!

So, in spite of Marcus' long-lived car, what else gives rise to
apex seal failure or other causes of engine rebuilds while the
engines have fewer than 120,000 miles on them?

Barry Gardner
Wheaton, IL


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org