Subject: Reasons for apex seal failure
From: Paul
Date: 2/12/2000, 10:48 AM

Bill Freeman wrote:

                              SNIP


Readers should also know that, while my 88 normally-aspirated
engine has one blown seal, the engine did not fail
catastrophically, still starts and runs, but will not idle below
2000 rpm and, of course, does not generate full power. That
sounds like enough power to get my plane somewhere safe to land
except perhaps over high elevation terrain where near-full power
output would be required to stay aloft. I feel good about that!

  I think that this relatively graceful failure mode is a big plus for the
rotary.  Certainly fuel system and ignition systems (& prob cooling system)
can give a "hard" failure (i.e. NO power), but the mechanical failures seem
to be more likely to be "soft".  Keeping this in perspective, one of the
more common failures of a 'real' airplane engine is an exh valve
failure.  While pretty catastrophic, these things manage to get the
pilot to an airport on partial power most of the time.  A broke rod is
usually the end, NOW, as my Dad verified a couple of years ago, without
damage to his Mooney or him or Mom.  Pretty exciting, tho!

Bill


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org