Subject: 2" dia pre-formed foam
From: Paul
Date: 2/13/2000, 11:59 AM


Ernesto Sanchez wrote:

Paul,
    I do not remember if this was mentioned before to this group but I just
discovered a source of pre-formed foam to make intake runners.  We just came
back from the local crafts store.  We were looking for stuff for my son's
science project when I saw a whole wall full of carved foam products.  They
had 1.5" to 2"  dia foam poles and 12" dia circles (360 degree wreath bases)
made out of 1.5 dia white foam.  I'm thinking of cutting up the wreath base
for the curves pieces of my manifold.  A person could build the manifold out
of foam (bases out of alum plate), cover it with a release agent (tape?),
then cover it with glass cloth and epoxy.  Later, after it had cured, pour
gas in it to melt the foam out (it looks like Styrofoam).  I bought the 2"
dia foam ($1.27) to see if I can shape it with heat.  I'll report back the
results.
Ernesto Sanchez
E-Racer 319
es12043@utech.net

We had a long discussion on this a while back. This is a breakthrough
discovery for tuned hand layed up composite intake manifolds.
Great work Ernesto.

Paul Lamar

Ernesto,
  verify that the foam dissolves well in some common (cheap) solvent
(like gasoline) before you go too far.  The most common foam for the
flower arrangment people does not dissolve in gas (probably urethane).
If it works you can build up a pretty nice wrapped up intake.

Bill

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org