Subject: Aluminum end housings.
From: Paul
Date: 2/13/2000, 12:01 PM

Bill Freeman wrote:



The Wankel GMBH engines use nikasil on the rotor housings, but the end
housings are flame sprayed molybdenum coating. Moly coating (in my
experience) is very variable in its performance. Sometimes it works great,
sometimes it wears quickly. We studied this extensively at Deere, and could
not find a reason for the variability. We also did not at the time find a
better (cost vs. performance) alternative, although we were hopeful that
hypereutectic aluminum alloys would be the answer.

Jon Lauter
Rotary Power Marine Corporation
www.rotarymarine.com

Jon,

Is hypereutectic the generic term for the non-equilibrium Si-Al alloys
which were first used in the Reynolds 510 cu. in. racing "Chevy" V8s,
and then on the Vega?   The surface of the cyl bore molds are chilled to
freeze out the Si as high Si nodules in a high Al matrix, a non-equilibrium,
but very wear resistant state.  Altho the alloy got very poor work-of-mouth
due to the undersized Vega cooling system which caused rampant destruction
of the non-equilibrium wear layer, apparently it is very widely used with
good results by Mercedes, Volvo, and Porsche (water coolers).

Is it reasonable to assume that the end housing wear conditions are
significantly
less 'difficult' compared to the rotor housing?

Bill


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org