Subject: Aluminum end housings.
From: Paul
Date: 2/14/2000, 12:37 PM


Gary Casey wrote:

A eutectic alloy is one where the two components (in this case aluminum
and silicon)
stay in solution the longest possible time.  This is possible at only one
mixture
ratio.  If the ratio is anything else, the solution will separate during
cooling
solidify gradually in a sort of slush.  It also corresponds to a mixture
with the
lowest possible melting point - like the 63-37 ratio for solder.  Since
aluminum is
the base material, the term "hyper" refers to the concentration of
silicon, so a
"hypereutectic" aluminum-silicon alloy is one that has a higher
concentration of
silicon than the eutectic alloy.  (I forgot what that ratio is)



Thanks Gary  - been c copule of decades since my materials class, and I was
a bit fuzzy on the details, altho I knew the basics of why the alum-Si alloy
worked
for cyl walls, and why it turns to usless mush if overheated.

Bill


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org