Subject: Alumiunm end housings
From: Paul
Date: 2/14/2000, 9:57 AM

snips...........
Getting
adequate strength in the aluminum housing hub area was also a problem (don't
forget that turbo stratified charge combustion pressures can exceed 1200psi
easily). 

snips....

Jon Lauter
Rotary Power Marine Corporation
www.rotarymarine.com

Jim Mederer at Racing Beat also had problems with strength in this area
of his aluminum end housings. The steel/aluminum composite housing
should help in this matter. A 1/8 inch thick  4130 or 4340 steel plate ought
to take all the loads from the mains all by itself.

What strikes me about the John Deere work and all those that have
come and gone before or since never got around to trying the steel/aluminum
composite rotor housing that Mazda has had so much success with.
Perhaps it only works with smaller engines.

It always amazes me that aluminum cylinder heads even work at all.
You have these 3000 degree combustion gases thousandths of an inch away
from a material that melts around 1000 degrees. The very thin
insulating film of cooler gases is the only thing between you and
catastrophic failure. The least little bit of unusually turbulence or
shock wave from pre ignition or detonation could damage the aluminum.
Heck a steam pocket in there could cause the same thing.
This is probably the reason they had so much trouble with coatings.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org