Subject: Carb air inlet orientation to increase ram pressure/manifold pressure]
From: Paul
Date: 2/14/2000, 8:38 PM

David Carter wrote:

For Neil K:
I just printed your Feb 9th 6:13pm e-mail and attached picture of your
Lanceair (correct name?)  Greg Nelson in my local EAA chapter 223 has
about 60 hours on his newly built Lanceair.  He reshaped the carb air
inlet so it pointed slightly right to pick up more of slanted prop wash
(used Lyc engine and normal direction of rotation).

We fly at sea level here on SE Texas Gulf coast.  He uses an air filter
that is a high flow/low resistance paper cartridge, but oiled so won't
disintegrate in rain.  Given a local atmospheric pressure and altimeter
setting of 30.00" Hg, instead of the 29" MAP that I see in the 180hp Lyc
Mooney I fly (paper filter) (a 1 inch drop) and the 28" MAP (2 inch
drop) that I see in the 235hp Cessna 182 I fly (with crummy oiled foam
rubber filter), Greg see 31 inches INITIALLY on takeoff (or climb at ___
mph.  If he levels off at 1000' where atmospheric pressure has dropped
1" to 29" and accelerates to 180 IAF, his MAP increases to 32" - a
prop/ram air boost of 3 inches over atmospheric.

If it were assumed that a normally oriented carb air intake with paper
filter would drop MAP to 1" below local air pressure, then he is seeing
a 4" boost above what other airplanes are getting at 180IAS and 3" on
takeoff.

David Carter


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org