One major drawback to the hard thermal spray coatings (D-gun, HVOF, plasma,
etc.) is the cost for finishing. The coatings must be ground with diamond
wheels and the coatings start off very rough, so a lot of material has to be
removed. The coatings are nearly as hard as the diamond wheel -- tungsten
carbide or chrome carbide coatings are commonly used -- so the grinding takes
a long time. Then, the coatings must be lapped with using diamond paper and a
specially designed machine. Lapping to a very fine finish -- better than
about 8 microinches -- is required because the grinding process leaves sharp
carbides exposed. Millions of cutting tools waiting to machine down the nice
apex seals as they slide on by.
All in all, the Mazda system works very well for its intendended application.
I bet even Mazda never thought the chrome plating would be capable of the
stresses imposed in the latest twin turbo or new renesis engines.
Perserverence and continuous development were the keys.
Jon
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org