Russell Kent wrote:
Barry Gardner wrote:
Over on one of the car lists, they suggest that a lean fuel condition
can cause a blown apex seal. However, on this list (based, perhaps
exclusively, on Tracy's experience), the settled wisdom is that a lean
condition can be safely tolerated because there are no valves to burn.
Can a lean condition cause apex seal problems?
Keep in mind that if you plug the crankcase oil injector and use
two-stroke mixed with the fuel as apex lubricant, that when you lean the
engine, you are also reducing the amount of apex lube (per RPM). I would
think that if you are aggressively leaning, then you need to be careful
to maintain a low oil:fuel ratio. As low as 1:64 perhaps? That would be
2 oz. per gallon.
Russell Kent
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org