Subject: Reasons for apex seal failure
From: Paul
Date: 2/15/2000, 10:21 PM


Barry Gardner wrote:

Over on one of the car lists, they suggest that a lean fuel condition
can cause a blown apex seal. However, on this list (based, perhaps
exclusively, on Tracy's experience), the settled wisdom is that a lean
condition can be safely tolerated because there are no valves to burn.
Can a lean condition cause apex seal problems?

I thought that a lean mixture could result in a backfire, or pre-ignition.

This was bad for Holley Power valves, but I don't think anyone lost Internal
Engine Parts.  Detonation could break things, but I don't think a Lean
mixture is the cause of detonation.  Too much timing advance, or hot carbon
in the Combustions chamber.

tc

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org