Somebody had this idea a while back and I finally
got around to drawing it up. Really looks good.
Prop and thrust line are in the stock Coot
positions. The whole engine and pylon are rubber
mounted on the spars. Get a catalog from Barry
for the industrial rubber mounts.
Gets the weight of the engine down and the frontal
area of the prop drive is reduced for more thrust
and lower drag.
The pulleys shown are 12 inch
and four inch for a 3:1 PSRU ratio. Lots of torque and HP for
a three or four blade six foot prop. Allows the engine to run
up to 8500 RPM for takeoff. The lower pulley needs
to be straddle mounted with an outer bearing of course.
The steel tube pylon is easy to make and is probably lighter
than trying to mount the engine up top. It must be completely triangulated
on all sides for torsional rigidity off the engine. You could get to the
engine from the cockpit if needed.
As before two rads can be mounted on either side of the
pylon in a V formation with the open part of the V forward.
In this case they can extend up along side the prop shaft for
more area. Let the belt hang out in the
breeze for good cooling.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org