Subject: PT6 gear box
From: Paul
Date: 2/20/2000, 7:45 AM

As far as I can tell by scaling the 2nd stage  gears from the drawing 
Archie sent the second stage is about 5:1 gear reduction.
The first stage must then be about 3:1 for the overall 15:1.

I was hoping it would be the other way around. The 3:1 in the
second stage. Oh well such is life.

The power is taken from the planet carrier with the ring gear fixed.

This would be OK with a real high speed rotary engine say 9000 RPM
and a very low speed prop (read large diameter) 1800 RPM.
Looks like it it is not too useful for an every day airplane.
OK for a Reno racer however.

A slight redesign of the planet carrier part and the sun gear could
change this ratio for the better but it would be costly.
This would entail all new, larger planet gears and a smaller 
sun gear I think.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

PT6-GB-draw.gif