Subject: huh? Electric super chargers???
From: Paul
Date: 2/20/2000, 8:50 PM



IMHO the biggest advantage of intake boost on an aircraft is the ability to
fly higher on x-country trips.  This allows for a higher True AS at the fuel
burn of a lower Indicated AS, also affording weather avoidance.  I have
decided not to turbo-charge because of cost, complexity and fuel burn, and I
am not convinced the that 13B is capable of sustained hp above 180 unless
more significantly modified.  I would really only use Turbo on T.O., high
altitude cruse, and possibly climb (the rest of the time I would be throttled
back to ~180hp.)   Now, if this electric supercharger were not too expensive
(and that is a VERY big if) I'm sure it wouldn't be too difficult to install.
 Then it could be switched on for short-field T.O. and those relatively rare
long x-countries or times when I need to impress my friends.  Otherwise it
could be shut off, even bypassed, and wouldn't be placing any extra demands
on the engine like a mechanical supercharger.

I dont imagine that this fits the bill because it is probably not available
for a while and it is probably expensive.  But I'll keep an ear open.

Dave Leonard

If you check the web site Dave it is only good for a 1.9 liter engine
and then only for five or ten seconds. All it really does is help the
conventional turbo charger accelerate faster.

It is real hard to get the 20 HP or so out of a 12 volt motor required
by a real super charger. 20 HP assuming 100% efficiency is  14,920 watts.
At 12 volts that is 1,243 amps!!! You will need a REALLY BIG alternator :-)

This is a gimmick like the electric water pump. Besides, electric motors
are only about 80% efficient or so the rest goes out the window in terms of
waste heat. That 1200 amps soon becomes 1400 amps. Have we talked about
the weight of the 20 HP 12 volt DC motor yet? 

Outfits like this count on the fact that most people never studied electrical
engineering or physics.

I also take issue with the 180 HP continuous rating of the 13B. That
was before two cycle oil. All of Mazda's early work on cooling was based on 
the coking temperature of regular motor oil. Therefore the temperature
of such things as the inner wall of the rotor housing and the rotor itself
could be increased if a better, higher temp oil was available. With modern
synthetics that is indeed what we have.  I think and guess a 13B should be 
capable of 250 HP continuous no problem. Cooling is the only issue as the
structurally capabilities of the engine are far higher as proven by the 
drag racers with their 700 HP nitrous burning, turbo, 10,000 RPM engines.

Jim Mederer is looking at 300 HP per rotor peak and 200 HP per rotor
continuous with only slight improvements to the cooling system.
BTW Burning only 100LL aviation fuel. The engine has been on the dyno for 
the last six months or so doing durability testing. That of course would be 
600 HP peak and 400 HP continuous for a 13B two rotor version.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org