Subject: cs props new all steel hub.
From: Paul
Date: 2/21/2000, 5:01 PM

 
At 01:10 PM 2/21/00 -0800, you wrote:

This is all heat treated 4130 steel so I will not have to worry about fatigue
as I would if it was hogged out of a big block of aluminum.
It is bullet proof if a bit heavier.

This is the top view. the side view will follow. Any questions
or suggestions?

The three major external parts are the flange,
the shank and the lateral tube. The four major internal parts
are the two prop shanks, the alignment tube and the pitch change
yoke. The hardened and ground, split ball bearing races are
standard US prop manufacturers features.

Paul Lamar


Jeff Spitzer wrote:

I don't think the snaprings can carry all the blade centrifugal loads.  Did
you chuck on this?

Jeff Spitzer

Sure! Snap rings are amazing. Especially with an internal sleeve lock.
Machinery's Handbook.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

snaprin3.GIF