Subject: cs props new all steel hub.
From: Paul
Date: 2/22/2000, 7:59 AM

Erik Duley wrote:

m=5lb / 2.205lb/kg = 2.3kg
r=1.5ft / 3.281ft/m = 0.46m
v=3000rev/min / 60secs/min * PI * 2 * 0.46m = 144m/s
F=2.3*144^2 / 0.46 = 103.6kN = 23,000 lb

metrics are'nt so bad :-)

Are the needle bearings retained somehow?
Also at rest, will one of the blades unload
and its drive pin rest on the other?

Erik


Thanks for the math check Eric. 

No the blades are backed up by the 0.75" thick pitch change yoke. 

The needle bearings come in sheet metal cups
that are pressed into the blade shanks. The alignment tube is hardened
and ground for the needles to run on. Very little movement or load here.
Most of the blade bending load on the hub is countered by centrifugal
force of the blade. Like a helicopter. Only when the pitch is changed is 
there any movement. Nylon bushings would probably work as well.
Be a lot cheaper. BTW most props merely dispense with this feature.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org