BTW one newton is equal to .22481 pounds. God, I hate the
metric system! I should have up loaded the next page for the
95 mm shaft wherein it rates that snap ring at 215 kN or 215,000 Newtons
or 48,000 pounds as long as we are not going to Mars.
BTW this rating has a safety factor of four it says here in
fine print at the bottom of the page!
If the blade weighs 5 pounds and the blade CG is 1.5 foot out at 3000 RPM
it is going 471 feet per second. Mass of the blade is .155 slugs.
I get 23,000 pounds of force for a 5 pound blade. F = m*v^2/r
Most of the weight of the blade is really near the hub so this is a very worst
case scenario. I will put two snap rings in there for insurance.
Check my math.
Paul Lamar
Jeff Spitzer wrote:
Yes, 25,000 lb is my rule of thumb for a typical GA prop blade. Didn't
you like my pun/misspelling when I asked if you chucked the loads?
Jeff Spitzer
Sorry Jeff I missed it. :-) I am thinking of doing a computer program to add up
all the incremental mass forces along the blade radius. Do you have
a math function for typical mass distribution verses blade radii?
Lacking that a simple way of estimating/calculating the area of a wing rib?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org