Subject: cs props new all steel hub.
From: Paul
Date: 2/22/2000, 11:56 AM

Colin Smith wrote:

Paul wrote:


This is the top view. the side view will follow. Any questions
or suggestions?

 The hardened and ground, split ball bearing races are
standard US prop manufacturers features.


Colin Smith wrote:

Maybe use snap rings on the root end of the blade retainers. This should allow use of standard angular thrust races and much easier manufacture. External ring would be retained by main hub bore.

Colin

Not sure I follow. Sounds good. Got a sketch?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org