R c wrote:
Paul,
Turbine compounding seems like a worthwhile use of waste heat from exhaust
gas. Your high-speed alternator suggestion has peaked my curiosity and
interest. I suppose any energy conversion losses would be a non-issue.
Some questions in this regard.
What are the typical HP losses as a percentage of total HP for the following
items?
Alternator
A 70 amp alternator is about 840 watts so figure about a 1.5 HP
Water pump
I would say 5 HP as a wild guess. Don't really know.
The Turbine itself (exhaust restriction)
Very little depending on the size. Larger turbines are lower loss
ironically. I would guess less than 1 HP.
Cooling drag losses
That's a hard one. Depends on the speed of the airplane and how well
the ducts and rads are designed. Could be as little as zero
if everything is done exactly right.
The thought came to mind that electric fans for the radiator could be
powered from this high-speed alternator setup. I assume that this would
counter act any radiator drag loss. What do you think?
Well they would help but don't forget the HP for the fans.
Also, do you know of any electric water pumps, high-speed water pumps,
turbines or reduction units available out there? I saw a Paxton unit on the
ACRE website but I'm not sure were to go to get more info on it.
The electric water pumps out there are for Chevy V8. I am not sure they
would have enough flow for the Mazda at high continuous power.
Probably not.
Much appreciated.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org