Subject: cs props new all steel hub.
From: Paul
Date: 2/24/2000, 12:35 AM


Vance Jaqua wrote:


The snap ring retention scares me - stress conc in
the
grooves, and snap rings in generall - Vance

Common prop design  practice. That 4130 heat treated
steel tube is way over
designed for carbon fiber blades. I will size it so
the stress level is below
10K if you like. :-) Also use two snap rings per
blade.
the screw on part of the blade can also incorporate
a sleeve that will
positively lock the snap ring in place with no
possibility of becoming
dislodged.

Paul Lamar


Vance Jaqua wrote:

I think almost everyone has sketched up a variable
pitch hub at one time or another - a scheme I like is
sort of like a chinese puzzle that assembles without
any fasteners - based on composite or wood/composite
blades with a steel retention collar - the blades are
pushed in to the loading hole - balls loaded, and then
the blades are forced back out by the installation of
the screw driven actuator block, while the blades are
turned to track the tabs into the groove - see sketch
Vance

This is a brilliant idea Vance. You should patent it.
Wow! I am impressed. Super simple!

I will draw up a new hub design using this idea if you don't 
mind. I love it. I think we can insert the balls from inside 
the housing and forego the holes. The yoke can prevent
the blade shanks from moving in and releasing the balls.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Vances-prop-hub.gif