R c wrote:
Thanks Paul,
Are the 19x22x2 demensions for a 13b raditor or water cooled oilcooler set
up?
That's for the rad. You will need an oil cooler about 1/2 that size.
Use one that is two inches or less in thickness so the air will
flow through it during low speed climbs. One third of all the cooling
requirements of the 13B are in the oil cooling system.
People seem to be getting away with using the stock RX7 oil cooler
but that may be a little marginal in my view. Perhaps the climb is
over with fast enough so the oil temp does not get a chance
to stabilize.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org