Subject: oil/water heat exchangers
From: Paul
Date: 2/24/2000, 7:37 AM


In a message dated 2/24/2000 7:59:22 AM Tokyo Standard Time,

 >   Ive brought this subject up before but I'm looking at it again now. I'm
 > currently mocking up systems and would still like to use an oil/water
heat
 > exchanger in place of a standard oil cooler. When I was looking at this
and
 > discussed it with Fred Moreno (are you still on this list Fred?) it
 > appeared that none of the exchangers on the market had enough cooling
 > capacity to do the job for the rotary at a continuous 75% power. Does any
 > one see a problem with building one of these using a conventional air/oil
 > cooler of appropriate size? The plan would be to use a stock Mazda cooler
 > (or something of equivalent size) and enclose it in a box and then pass
 > coolant throught the core/fins on its way to the water pump inlet.
 > Something like this would make packaging in my airfame much easier. So
what
 > do you guys think?
 >
 > Mike Wills


Mike,
I too am interested in an exchanger.  However, IMHO your design, although it
would work, is too complex and heavy.  With two different fliuids you would
be able to take advantage of contra flow qualities.  An adequate heat
exchanger would be a fraction of the size of the stock oil cooler.  But now
you have to cool the liquid, which will likely require an additional
radiator.

Powersport is using a heat exchanger for their 210hp engine.  They are
selling it separately for $250 I think.  Im not sure how big it is though.

I get to San Diego in 3 Weeks!!!  (not that I'm counting)

Dave Leonard

Congratulations on coming home Dave. Too bad we could not get you
more assimilated into the Japanese culture while you were over there. :-)
We could use someone over there to smoke out 20B's:-)

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org