Mike,
I too am interested in an exchanger. However, IMHO your design,
although it
would work, is too complex and heavy. With two different fliuids you would
be able to take advantage of contra flow qualities. An adequate heat
exchanger would be a fraction of the size of the stock oil cooler. But now
you have to cool the liquid, which will likely require an additional
radiator.
Powersport is using a heat exchanger for their 210hp engine. They are
selling it separately for $250 I think. Im not sure how big it is though.
I get to San Diego in 3 Weeks!!! (not that I'm counting)
Dave Leonard
Dave,
Ive looked at oil/water coolers form Setrab, CR Racing, Aeroquip, and
Fluidyne. The highest capacity exchanger Ive seen is the Fluidyne parallel
flow. It's rated at 80,000 BTU/hr. Fred Moreno thought it was marginal and
also didnt like the parallel flow concept. He recommended a series flow
cooler in the waterpump inlet. The Fluidyne cooler actually appears to be
their smallest air/oil cooler with a coolant jacket welded up around it.
This is what I'm thinking about only starting with a larger core.
Ive had one of the CR Racing coolers recommended by one of their
application engineers, but when I pressed him on capacity he said he would
have to get back to me. His recommendation was based on experience (in
other words his gut feeling). I'm not convinced any of these guys
understand how critical oil cooling is in the rotary, or how demanding the
aircraft requirements are. Fluidyne wont sell if they know the application
is aircraft.
I agree my planned setup will weigh slightly more than a conventional
rad/oil cooler config. As I see it this disadvantage is offset by the
flexibility in oil cooler placement and the simplification of
ducting/baffling. In my setup I could put the water/oil cooler right at the
firewall to keep the weight back as far as possible. This is also the place
where I seem to have under cowl space. Also this homemade oil/water cooler
could serve double duty as a surge tank and place to locate a coolant
filler cap.
Ive tried repeatedly to get info about Powersport's cooler. Either I've
done something to piss them off and its just me, or they arent prepared to
sell to anyone, because I cant get responses to my inquiries. If anyone
knows more about it I'd like to hear it.
Look forward to meeting you when you return home.
Mike Wills
They are not too good on email Mike. I have had the same problems.
I think you are going to have to call to get a yes or no.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org