Subject: oil/water heat exchangers
From: Paul
Date: 2/24/2000, 11:34 AM


You might want to look at some auxillary device to remove heat from the oil
pan like Tracy Crook did, but instead of using a coil of copper tubing, use
a finned heat exchanger mounted on a baffle plate sandwiched between the
engine and the pan. That way, oil would be forced to pass through the heat
exchanger on the way to the sump. Just an idea.

Brian Trubee
Redmond, Wa

  I thought about this some time ago. This was also addressed by Fred
Moreno a while back. The problem with an oil pan heat exchanger is that the
oil has insufficient flow, and heat transfer is related to flow rate. If
relying on an oil pan exchanger as the sole means of cooling it would have
to be very large. If the cooler is on the pressurized side of the system
the cooler can be much smaller. I'm no expert on this but this is how it
was explained to me by someone who is an expert.

  Also this removes one of the main advantages of the oil/water cooler as I
see it. That is the advantage of being able to locate it anywhere.

  Ive often wondered why Tracy did what he did to his oil pan instead of
using one of those small sandwich coolers that fit between the filter mount
pad and the oil filter to supplement the air/oil cooler. I know he tested
one of these as a replacement for the air/oil cooler but not as a supplement.

Mike Wills


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org