R c wrote:
Does anyone know what effect wear on the face of the end and intermediate
housings has on the power output and reliability of the 13B. I'm not
refering to rust or pitting, just your average wear. Is it a big deal?
I have a set of end housings that are still in very good condition and well
within spec. I?ll be putting in new side, corner, oil and apex seals. I
plan to baby this engine with Golden Spectro synthetic pre-mixed in the fuel
and Mobil 1 synthetic in the oil pan.
I?m wondering what effect new seals against slightly worn end housings will
have on the break in of the engine. Ideally I would like to start out with
end housings that are within .0005 flat. Would it be in my best interest
to hand lap these? And if so, which method of lapping is recommended?
R c you can get them lapped and re-nitrided by
LAPCO
5440 HWY. 55
Lake Wiley, SC
(803) 831-0761
Racing Beat in Anahiem CA also does lapping of end housings.
This is a good idea as your new seals will last longer.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org