tcarrico wrote:

R c wrote:

Does anyone have any suggestions for a high temp Epoxy resin suitable for
use in an oil/coolant heat exchanger?  Are there any that have adequate

heat

conductivity properties?

I have some info on the CD but I would not use it for an oil cooler.
It is only good for about 300 degrees F which is kind of marginal.

I would think that heat transfer would be worse.  It would probably
act more like an insulator.

tc

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org