OK John here is the first part drawing. The stress level is real
low so this hub should be bullet proof. We need to make at least
one for testing.(Two of these parts are required.) I will front the
money for the material if you wish.

Thanks for doing it John. Hopefully we can get Tracy to test it on his
test stand. No rush however As I am sure Tracy will be real busy
between now and Sun & Fun as I will.

Paul Lamar

Jeff Spitzer wrote:

I would mask everything but the bearing race and go for about Rc38 except
for the carburized race at Rc60.

Jeff Spitzer

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org