Dale Smith wrote:
Any items here (from rec.aviation.homebuilt) applicable to youtr
constant speed prop project? Also, how does one go about getting
in line for one of these?
Too soon for that but a kit may become available. Build your own blades.
Paul Lamar
Subject: Re: CAP or CS Prop Selections For Homebuilts
Date: Sun, 23 Jan 2000 08:07:58 GMT
From: dglauser@earthlink.net (David Glauser)
Reply-To: dglauserNOSPAM@earthlink.net
Newsgroups: rec.aviation.homebuilt
References: <869qh6$smm$1@merrimack.Dartmouth.EDU> <20000121121115.03697.00001001@ng-fr1.aol.com> <388a672f@news.nwlink.com>
On Sat, 22 Jan 2000 18:20:53 -0800, "ATE" <ate@nwlink.com> wrote:
I have seen ad's for Whirlwind Propellers and have visited their Web Site
but have not heard a word about anyone using one. Any Info?
Morris
I just got back from a Europa builder's meeting at Cable airport,
where the speaker was from Whirlwind. Kim Prout is using the Whirlwind
on his Europa and loves it. The prop and hub weigh 10.2 pounds.
Changing from his fixed-pitch Warp Drive 3-blade prop to a
constant-speed Whirlwind 2-blade prop added only about 3 pounds to the
plane. Best weight addition he ever did. He says his ground roll is
around 40% of the original, and rate of climb went from around 700-800
ft/min to around 1300. Look for a CAFE foundation report on the Europa
in an upcoming issue of Sport Aviation (probably March, or maybe
April). They usually keep the plane for a weekend or maybe 3 days. Kim
said they kept his for almost 2 weeks and did not want to return it.
They put over 25 hours on the plane, including several longer flights.
Anyway, back to the prop. Whirlwind has mostly built for larger
engines (mostly aerobatic planes). Apparently those props are wood
core covered with carbon fiber, with a stainless steel leading edge.
The new props for the Rotax engine came from a government contract to
develop a lightweight constant-speed prop specifically for unmanned
aerial reconnaisance vehicles (remote-controlled planes) that ran on a
Rotax 914. This prop is entirely composite (glass and carbon fiber)
pre-preg, cured at 250 degrees under 6 atmospheres of pressure. They
have a stainless steel leading edge and are gorgeous as well as very
light. The hub is machined from a chunk of billet, then heat-treated,
machined again, heat-treated, shot-peened, and anodized. The small
prop (it is aimed at engines in the 80-120 hp range) is $4500 ($4850
with a governor, I think). Much cheaper than any other.
I'm planning on installing one on my Europa - I'd rather use the
non-turbocharged 912S and a CS prop than spend the extra dollars for
the 914 and have to use a fixed-pitch prop.
David
N82GT (someday)
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org