Subject: Something to add to your annual check list.
From: Paul
Date: 2/29/2000, 2:00 AM
To: Plugsup

Neil K wrote:

To all,

        Here is something to add to your annual checklist....

        Today, I was modifying my cooling system slightly by adding
a second vent/burp line from the oil/water exchanger to my
header tank.  In the process I had to pull the line running
from end housing to the header tank and pull out the
fittings.  Both fittings had a collection of crud in them
almost plugging them off.

        Now before anyone panics... this crud accumulated over a
period of 12 years and the fittings I use are for 1/4" AL
tubing (AN-4) which have pretty small openings.  I'm not
about to change the size of the fittings because of this but
I will have a look at them every annual or so.

Neil


Your engine is talking to you Neil. If I were you I would take
it apart and inspect the critical water passages that pass by
the hottest part of the engines near the spark plugs. It is
possible that these too are cruded up as they are now near
the top of the engines and bubbles rise. 

If you have some
hard water around put it in a bowl and let it sit for a couple
of weeks. Notice that the dissolved minerals tend to accumulate
or precipitate out around the water line.
With the engine in the upright position this crude tends to accumulate
in a much cooler part of the engine.

BTW Continental is having on going problems with their water cooled
Voyager aircraft engines.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org