Charlie and Tupper England wrote:

Posting for a friend from the Mustang list. Anyone in central Texas who
can help?

Charlie,
            I'm am looking for builder assistance to help me get started
with my Mustang II project. If you are a member of the RV list, could you
please post this message to the list. Thank you, John

Howdy Ya'll,
         I purchased a partialy built kitplane last Xmas (center section,
fuselage, gear and tail almost complete). The rivet work is "a little less
than special" and in some places, a lot less than special. I'm looking for
someone with lots of metal work experience to take a look at what I've got.
And also get me started in the right direction. There are a few places where
I just don't know. I've tried the local EAA chapters, ect without success.
Does anyone know of an experienced builder in the Central Texas (Killeen /
Grey AAF) area that can help? Should have most of my tools by the end of the
month. Thanks, John.

norquist@n-link.com

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org