Subject: New Apex seal oil pump adapter.
From: Paul
Date: 3/6/2000, 10:30 AM


Richard Sohn brought this to the Shady Bend Rotary Engine flyin.
It is an adapter that allows the stock pump to draw apex seal oil
>from a separate reservoir containing two cycle oil for those people that
hate mixing oil with the gas. The RX7 market should be huge for this
device.
The four hoses indicate it is an early pump. Later pumps use only
two lines for the oil injectors. The other two lines used to inject
oil into the carb. It should work fine with later two line oil injection
pumps.

Paul Lamar


Paul,
I seem to remember an earlier discussion that indicated that it would be
difficult to make an adapter, because the oil-injector pump or some parts
were lubed by the engine oil, and some was bled back to the crank-case.
I
may be all-wet, but how does Richard Sohn overcome this -- or am I
remembering wrong?

At any rate, this is a nice accessory if it works as planned , because a
reservoir can be constructed that is calibrated with the # of gallons of
fuel
and a quick visual check on preflight will both tell you if you have
enough,
and if it has been injecting on the previous flight.

Hoping it works well.
Bill

The block you see is a reservoir that is gravity fed just like the stock
apex seal oiling system. Most of us assumed the stock pump is pressure fed
and that is not the case. It is gravity fed.

There is a pump shaft extension and an oil seal to keep the two cycle
oil from flowing back into the main oiling system.

Therefor the pump itself is lubed from the two cycle oil. Very clever
on the part of Richard Sohn. Thanks again Richard.

Do we need a sketch?

Paul Lamar
--------------

   It would be relatively easy to adapt a gauge (perhaps from a motorcycle
   fuel tank) or a simple warning light triggered from the reservoir to
   notify the operator when the oil level is low.  I would certainly do
   this for an airplane application.

   What a fantastic idea this is.  As has been previously mentioned the
   market for this really extends to all rotary applications, not just
   airplane specific.  My street driven 13BT would very much benefit from
   this.  I wonder how much Richard wants to make me one?

   John Vitamvas


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org