Subject: My Fuel System Problem (formerly My ride in the RV Otter at Shady Bend)
From: Paul
Date: 3/7/2000, 6:43 PM



Hi Paul/Tracy

    Again, sorry I couldn't make it to the flyin, really would have been
great.
After two solid days of trouble shooting and swearing, I finally solved the
problem.  The problem has nothing to do with the manifold (at least
directly).

When I decided to emulate Tracy's manifold, that meant giving up my orginaly
set of fuel injectors as they were the incorrect phyiscally format to fit
the block ports.  So I got a number of used injectors from a local Rx-7
shade tree rebuilder.  The first problem was a bad injector on the block
which of course is hiddened by the manifold tubes which mean I had to
disassemble the intake to get to it.  Fortunately that just took time.

After replacing the bad primary injector, I tried starting the engine again,
while below the staging rpm(around 3000) the two inner injectors would run
the engine fine at least to 3000 rpm, however when the ECP "staged" to
include the secondary injectors, the engine popped, sputtered, shuddered,
backfired and other assorted evil actions.  Also, my fule pressure was
fluctuating by 5-10 psi.

While all this was going on I noticed one EGT was 300F higher than the
other.  Aha, I though the chamber with the cold EGT is being flooded by a
injector that is sticking open. Double Aha!, that could also account for the
flucuating fuel pressure.

Well,  after swapping out secondary injectors for a day and getting
confusing results, I resorted to the old process of - elminate each componet
in the fuel system one at a time.  So using various adapters, I started by
passing components and found out that my fuel pressure regulator had gone
south.  The pumps would keep the pressure between 30-40 psi (at least the
response time of the fuel pressure indicator and gauge indicated so) while
on, but the pressure would drop to zero once the pump was off.  Normally, my
system would hold fuel pressure to 30 psi for several days or a week.

So replaced the fule pressure regulator and decided to replace the fuel
filters while at it in case I had gotten some crud into the system.  I again
fired it up.  It ran better and much smoother below 3000 rpm, but above the
staging point I was still getting a mess.  To make a long story somewhat
shorter, late this evening I finally found the bad injector and replaced it
with the only good one out of the three remaining (of course it was the last
one tried).

With the fule pressure regulator and good injectors in, I had to decrease
the injector timing fuel map by 20% as these flowed 20% more fuel than my
old injectors. Fired it up and let the engine warm up, now running very
nicely and then reved it up to 5200 rpm which is 200 rpm higher than I got
on static run up with the old system.  I won't get to find out if the
system's "dynamic boost" is effective until I get it in the air, but the 200
additional rpm for take off will be welcomed.  Prop is same a Tracy's old
wooden one with 68x72".

I intend to refine the fuel map tomorrow, and hope to make a test flight on
Thrusday.  Will report the results after the flight.  My calculatons
indicate the lenght of my runners should start promoting the dynamic
supercharging effect beginning around 5500-5700 rpm and peak at 6000 rpm.

Ed

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org