Bill Freeman wrote:

Paul,

I would suggest good old wood for the prop core.  The
high damping of the wood core is very beneficial.  Perhaps
the syntactic epoxy core would also have good damping, but
wood is definitely good.  Also, relatively easy to carve.

If you carve the wood "core" to have the exterior contour
that you want in the final prop, then remove enough on the
lifting surface (uniformly) to apply your carbon, you'll
be very close to final shape.  Uniformly sand away the rear
surface, probably completely eliminating the wood in the outboard
3-4 inches or more.  The tips should be about 6% thickness
and pure carbon.  I recommend a ply schedule with alternating
plus and minus 30 deg from the long axis of the blades for
a good combination of torsional and bending stiffness.

I've never tried to wrap carbon into a tight radius, so not sure
if you can even attempt to wrap the leading edges near the tip.
Avoiding a butt joint on the tip LE would be good if possible.

Bill

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org