Vance Jaqua wrote:

Paul - We have to get together in how to transfer the
motor. in the interim here are the installation
dimsnsions as measured. the mounting holes could be
drilled out for a larger bolt, but room for the head
or nut starts getting tight. I am also enclosing a
sketch of a centerstick scheme that I have sent to Bob
Reed.
Vance

I got to pick up a couple of conduit couplings for John Moran (who is
doing the machining) so I could send him the motor when I send him
the couplings. How about at your house tomorrow night?

Email me your address and phone number. If something comes up and I 
can't make it I will call.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org