quichote wrote:

Paul wrote:

I might be doing some programing on the EFI user interface display to help out
Tracy. Since you are the guys going to be using this what would you like
to see? We are limited to a four line, forty character back lit LCD.
So far Tracy has about a dozen parameters he would like to display.

How's this for a vague response, as much pertinent info as possible.

Chris Cosman

OK it is a start :-)

Here is the complete list so far. 

1.    O2 sensor output.  
2.    MAP  manifold pressure 
3.    Air temp (engine inlet ait temp) 
4.    PGM  current setting of programming knob. 
5.    Mixture current setting of mixture knob  
6.    Fuel Flow 
7.    Table data in use.  
8.    engine speed 
9.    Table address  Address of current table entry in use.
10.    Staging flag  If 1 then fuel flow must be divided by
       2 (one injector per rotor in use)

Any comments?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org