Sorry John I had to revise this yet again. The Globe gear motor
that Vance loaned us has a different shaft configuration than
the Pittman so here is the revised drawing. I went to slightly larger
thrust bearings and a three 10-32 screw clamping arrangement for the 
motor output shaft. Access holes in the motor mounting aluminum slug 
for tightening the 10-32 clamp screws will be necessary.
I also went back to the snap ring to locate the lower thrust bearing
as I could not figure out how to assemble it otherwise.
The motor mounting slug is held in with screws through the motor mounting
tube.

I will send you a DXF under separate cover.
I will also ship the motor and a two inch  conduit coupling so you can match
the threads.

Perry, I will be shipping your couplings as well. Can you handle aligning the
couplings
with the wood prop blanks? Do you need something machined for doing this?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org