Subject: Mazda Rotary Truck?
From: Paul
Date: 3/16/2000, 9:31 AM


mike wrote:

Paul.

Do you know which mazda truck had the rotary engine? I think it would
make for a
great
engine break in vehicle (with a good load of wood.) Was it the B2000?

Thanks, Mike

It may be the B2000 but I am not sure. Anybody know?
Every time I see a Mazda truck on the road I try to figure out if it has a
rotary.

I would like to buy one do do some cooling test. I want to mount a duct in
the bed
and plumb the coolant back to the rad in the duct. I will then build a
trailer
with a perpendicular wall  to increase the HP required. Or perhaps load up
the
bed with weight and find a long steep hill. Third plan is go out into the
desert and
find
a road to drive flat out on.

Paul Lamar


The Mazda rotary truck was only built for a few years - '74-76, I believe.
I know that it predated the introduction of the RX-7.  It had a 4-port 13B,
with a ribcase 5-speed.  I imagine it was similar to whatever 4-cyl pickup
mazda was making at the time.

I have seen two of them in my life - they seem to rust out rather badly.

John Vitamvas


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org