Patricia & Bradley Sievert wrote:

What type high temp epoxy should I use to hold the peripheral ports in
the rotor housing? What type devcon is used to fill the old unused side
ports? Thank you,Brad

BTW the pressure unbalance that Jim mentioned in the 
R-Beat catalog with peripheral ports can be simply fixed.

When you fill the side port with epoxy (Jim recommends Steel Devcon)
leave about a 1/16 to 1/8 inch cavity. That will equalize the 
pressure from one side of the rotor to the other. Jim and I were 
talking about that last week when I was down there. 

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org