Subject: Rain cuffs for composite props
From: Paul
Date: 3/21/2000, 7:53 PM


Seems to me a metal blade is a sledge hammer approach to the problem
not to mention the extra weight of PSRU and blades.

Composite props usually require an electro formed compound curved nickel
cuff.
These are quite expensive but a thin stainless cuff could be made and
bonded on.
The trick is welding the 0.016 inch thin SS parts together so they fit
a compound curve prop blade leading edge. Good argument for a straight
taper blade instead. That way the SS cuff can be merely bent and glued on.
(Bill, joa & Perry are you listening?:-))

Rubber or urethane also seems to work. Bonding it on seems to be the
problem.


George Lendich wrote:

Going by memory, someone mentioned a pourable DEVCON product for the
leading edge of timber props. Router back the leading edge to give the most
area to stick (not a straight cut) set up a rough jig at the leading edge
and pour it in.
Sticks well in the uncured state.
The problem is sanding it back to shape as it doesn't sand very well, but
with a
small sander the excess tends to come off small balls - probably melted!!

Hope it helps - George

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org