Subject: power in a 13B rew
From: Paul
Date: 3/22/2000, 1:33 PM



Bill Freeman wrote:



Subject: (rx7) Got my car dynoed today.

                           snip

17.5psi       424rwhp

                              snip
Marc,

What modifications have been completed on the motor dyno tested below?
Also, what kind of revs are required to put out this power (I am too lazy
to calculate it from the torque and power figures)?
The power output is very impressive (over 600hp at the flywheel?).

  let's see, 746 watts per HP,   "over 600" - 424 = over 176 hp lost in the
drive train = 131 Kilowatts.   I suspect that the tranny would melt if
this were true.  Assume <5% loss in the tranny for a manual box.
So, 424/0.95 = 446 hp at the flywheel or thereabouts.

Awfully impressive horsepower.  Must go like stink!

Bill

"Quirk, Kevin KA" wrote:

A 5% loss seems a bit low for the entire drivetrain as I assume that rwhp was the power measured 'at the wheels'.  Obviously it depends on the setup but I thought it would be a minimum of 15%.  Does anyone have any actual test results (motor tested on engine dyno and then compared to chassis dyno results)?

KQ


That is about right. If you had much more than that you would need big coolers
on the manual transmission oil and rear axle oil. 
A 1000 watt room heater is about 1.3 HP for a point of reference.

Of course no matter how much peak power you have it still only takes 40 HP to get 
the car down the road at 70-80 MPH so the 5% loss in the transmission and rear axle 
is not that much heat. NASCAR racers use coolers on both transmission and rear
axle as they are running over 200 MPH for a couple of hours.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org