Subject: Marcotte PSRU & 20B
From: Paul
Date: 3/26/2000, 5:27 PM


I was wrong!!!

The Marcotte PSRU DOES fit the 20B, if you do it
right.  They haven't gotten
the written instructions out yet.

What you have to do is (on the 13B, too)  pull the
big round aluminum disk
out of the PSRU, it becomes the new flywheel (pull
the torsion dampers out of
their holes), get a ring gear from a standard
transmission flywheel, and heat
shrink it onto the disk tight against the shoulder
that is provided. You now
have a new aluminum flywheel that does fit the
housing. A standard
transmission starter should work.  You cannot use
the original 20B starter
with this setup.

You do not use the flex plate flywheel at all.

Looks like it should work fine.

Bob Darrah


DENIS SMITH wrote:

Does Marcotte have a web site?  If so anybody have it?
 D Smith

It is on the ACRE NL web site but here it is again.

http://www.psrumarcotte.com/

Paul Lamar

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org