Subject: Radiant heat & eng. installation check list.
From: Paul
Date: 3/28/2000, 3:03 PM

I forgot to mention that radiant heat takes its biggest toll on a
facing radiator when the airplane is climbing out. At that point
the exhaust is the hottest and the airflow through the rad that
might be expected to keep it cool and possibly cool off the exhaust 
is the lowest. I would say a radiant heat shield between the exhaust 
components and any radiator in the vicinity is a must.

Don't forget. The sun is 93 million miles away and it is still capable
of warming the earth with radiant heat alone.

Here is a start on an engine installation check list.

A. Radiant heat shields between all rads and exhaust components.

B. No cantilevered plumping fittings. Fittings that have
mass extending out from the engine or PSRU are not allowed. They could
vibrate and break. Use a very short fitting and flex line instead.

C. No rigid lines carrying high pressure fuel or oil.
Use double braided SS flex hose instead.

D. No hose clamps on un-beaded coolant pipes. It is much better to use 
Wiggins couplings on all plumbing pipes over about one inch in
diameter. This goes for radiator fittings as well. Use AN hose 
and fittings on lines one inch or smaller.

E. Support all wires every two or three inches with Adel clamps or
tie wraps.

F. Use fire shield tubing on all fuel and oil hoses.

G. Enclose all wires that are required to keep the engine running in
fire shield tubing. Silicon wires are good. Teflon wires are best. Thin 
steel tube wire shields are also good.

H. Do not use double layer SCEET ducting in an intake system if there 
is a possibility it will be subject to a vacuum due to icing etc., etc..
 

Feel free to suggest other no no's.
Details like these are probably the leading cause of aircraft
engine power failures.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org