I finally got my car dynoed today (Thanks to Rotary Performance).  The car
performed pretty much of what I expected.  Here's my dyno numbers:

Boost            HP                Torque
7psi            290rwhp            ~220ft-lbs
10psi          335rwhp            Don't remember
16psi          398rwhp            ~325ft-lbs
17.5psi       424rwhp            Don't remember

All of these runs were made on pump gas with the a/f tune to around
12:1-12:2.

I'm pretty happy with these numbers consider the timing is much more
conservative than the PMS unit.
Marc

"Quirk, Kevin KA" wrote:

Marc,

What modifications have been completed on the motor dyno tested below?
Also, what kind of revs are required to put out this power (I am too lazy to calculate it from the torque and power figures)?
The power output is very impressive (over 600hp at the flywheel?).

Lastly, what is the octane rating of the 'pump gas' over your way?

KQ

"Quirk, Kevin KA" wrote:

Marc,
Any info. on the mods on your motor and the revs to achieve power figures listed?

KQ

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org