Use stainless steel for all your exhaust plumbing, and be prepared to
change
it out occasionally. The rotary exhaust is HOT! Also, keep the exhaust
length
as short as you can within the test cell and try to insulate and sheild
the
exhaust from the intake as best as possible. You will need a lot of test
cell
ventilation to keep reasonable intake air temperatures with that hot
exhaust. The heat has been the largest problem in my experience.
Jon Lauter
Rotary Power Marine Corporation
"Superflow SF901"
www.rotarymarine.com
Had not considered using any exhaust other than the one that goes with
the engine in order to accurately depict curve plots.
I DID, however forget the vast amount of heat generated.
Hmmmmmmmm...........
Archie
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org