lonwood wrote:
Doug and Patty wrote:
I read you every day . Lots of good stuff. What would happen if the
exhaust
pipes were run inside another set of pipes to keep heat and reflect it
back ?
Doug
This I think has been covered, but I have just fabricated my exhaust and in
one
place the tubes are about 1/2" from the cowling, which is aluminum. What is
the
best way to shield this? Also they come close to the engine mount tubes.
Will
an aluminum shield melt if it is within 1/2" of the exhaust tubes?
Lonnie
It will be close Lonnie. Perhaps 3/4 inch would be better. Louvers in
that area would also help. Better yet would be a thin SS panel insert with
louvers. The motor mount tubes should also be protected with a SS shield.
Cessna wraps asbestos or other insulation around the motor mount tubes
and then a metal shield on top of that. Check from time to time to
be sure moisture is not being trapped by the insulation and corroding the
motor mount tubes. I had to replace a couple of motor mount tubes on
my C182 for that reason.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org