Guys I need to borrow two stock intake manifolds. A six port version
and a four port version. I will pay shipping both ways.
I need these to get the holes in the right places.
Paul Lamar

lonwood wrote:

I found on the six port manifold that the holes in some places were over
1/16"
off from matching up with the ports. I think you would get more accurate
results
going off of the block.
Lonnie

Well I don't have a complete six port block. Whould anybody like to send me 
a junk six port front and rear housing? I'll pay shipping.

BTW some port matching will be possible with a die grinder.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org