Pretty close to correct. Fire was out when engine quit (oil stopped). The fire
initiated on the exhaust manifold, not the turbo. The oil cooler broke
identically to the first failure. It was a stress failure which I think was
caused by the vibration of the cantilevered inlet fitting and attached SS flex
hose. The Mazda factory oil cooler is going into the wing root just outside the
engine compartment. It actually skidded on the aluminum belly air scoop and 2 of
the (3) IVO props which really help limit the damage. IVO told me that because
the blades are flexible that the gearbox will probably be undamaged. Usually,
the a/c engine cranks are okay. I restarted the engine and everything was
working correctly.
Paul, I've been watching the discussion of where is the ideal place to position
the fuel injectors. From my racing days, the the reason you put them farther or
closer had to do primarily with where you wanted the cooling effect (big
negative heat of vaporization) to occur (in the runner or in the cylinder). I
suspect Mazda uses the primary injectors close to the port to assist cooling of
the rotor and for idle and mid-range fuel distribution. The secondaries are
farther away which lowers runner temp giving a cooler charge density, and more
power (especially on turbo engines). Putting the injectors a long distance from
the port and turning the fuel/air charge over 90 degrees in a smooth wall pipe
will probably cause distribution problems, particularly at lower rpms. If you
stay with the primary injectors in the block, and stage the secondary injectors
for higher rpm, the secondaries could probably be placed farther away than stock
w/o a concern. The only way to prove it is to dyno the system. Otherwise, it's
just an educated guess. Just my 2 cents worth.
Chuck
As I recall the oil cooler from Griffin Radiator came in a box made
with what suspiciously looked like Chinese Card board. :-)
Two separate engineers on separate dyno runs and entirely separate engines
have verified that the best place for the injectors for best BSFC
is at the start of the tubes. Jim Mederer at Racing Beat is probably the
best informed Mazda engine builder there is with almost thirty years
of rotary engine experience and Paul Ross at Alturdyne.
See my comments about fuel puddeling.
Since we are only concerned with high power and RPM over
4500 the derivability considerations are
outweighed by better fuel consumption consideration.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org