Tracy Crook wrote:

It may take me awhile to dig them up get  to you (I'm buried in work) but I
have the 6 & 4 port lower manifolds around tyhat you could borrow.   Put me
down for a "kit" too.  I'll need a 4 port.

Tracy Crook
rws@altavista.net
www.rotaryaviation.com

I think I have enough coming Tracy. Thanks anyway. 

Get back downstairs to the machine shop and go back to slaving away on 
those PSRU's and fuel injection computers :-)

BTW I have been thinking about your new prop shaft. You could taper it
to save weight and use the same rear plain bearing. This would be
easy if done on an NC lathe. Most of the bending moment is near
the front ball bearing.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org