Subject: IVO Magnum [new "High Pitch" version]
From: Paul
Date: 4/18/2000, 6:48 PM
To: plugsup

^ >> ^ >>>> Plugs UP <<<< ^ << ^ <<<
! >> ! >>>>>>>>><<<<<<<<< ! << ! <<<

Marvin Kaye wrote:


I visited Bill Dunbar today (Glasair Super IIRG, IO360 180hp, N465) and saw
his Ivo Magnum... it definitely has some serious pitch dialed in at the
root.  We couldn't go for a ride today, it was an airplane service day for
him but I will get a ride one day soon.

Bill's prop started out at 74" and he couldn't turn it beyond 2300 at the
high pitch range, definitely too much prop for the engine.  He took 2" off
the ends of each blade and now gets that 245IAS at lower altitudes in the
3-blade configuration and he is planning on trying it in the 2-blade setup
to see if it makes a difference.  He believes that he will get more revs
with 2 blades and expects a bit more speed as a result.  He is, however,
quite pleased with the way it's performing presently, as if he wants to
take it easy he can run 21"MAP at 2300RPM and sees 180IAS routinely, with a
7gph fuel burn.  Doesn't sound too bad to me for a 180hp Lycosaurus.

As for your friend slowing down as he approaches max pitch, the big
question (I would think) is whether it's a result of the engine running out
of steam and then being unable to keep up the revs, or if there's something
else going on with the prop that's all of a sudden causing some drag.  If
the former, I guess 70" might be too much prop for his engine, and maybe he
should try it in the 2-blade configuration to see if it makes a
difference... if the latter, there's obviously something not right with the
pitch characteristics of the propeller.  Time to do a bit more digging.
It'll be interesting to see how this all works out.

  <Marv>

Did you take your GPS with you Marv? :-) I did not think
you would get to go flying :-)

Marv, please take a bubble protractor over there and measure the pitch
one foot out from the center of the spinner on the back side of 
each blade when it is horzontal and let me know what they are. 

I will calculate a mean pitch angle
regardless whether the plane is level or not. Small angle  differences
in this area can mean a lot. Five degrees pitch difference can
mean the difference between generating positive or negative thrust
in this area. You can not tell this by looking at the prop blade.
What it does from one foot in matters little. We already know it
goes flat in this area. What it does from one foot out matters most.

If part of the blades are generating negative thrust they can absorb HP just like 
if they were generating positive thrust. So what RPM he can run has little
to do with it. 

Paul
 Homepage:  http://www.members.home.net/plugsup/
 Subscriptions:  http://olsusa.com:100/guest/RemoteListSummary/PlugsUP