I think I have enough coming Tracy. Thanks anyway.
Get back downstairs to the machine shop and go back to slaving away on
those PSRU's and fuel injection computers :-)
BTW I have been thinking about your new prop shaft. You could taper it
to save weight and use the same rear plain bearing. This would be
easy if done on an NC lathe. Most of the bending moment is near
the front ball bearing.
Paul Lamar
Tracy Crook wrote:
You read my mind. The shaft is indeed tapered and also gun drilled for
weight reasons. It may even be lighter than the current version.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org